|
The 200 motor is a permanent magnet germotor utilizing a cylindrical barium ferrite 2 pole field magnet. A
three bar commutator and a choice of carbon brushes or bifurcated silver alloy brushes provide long life,
quiet operation and low starting voltage. The three slot rotor is supported by permanently lubricated sintered
bronze bearings. Available in a wide range of speeds and an excellent choise for applications requiring reliability
and quiet operation at a low cost. Also available as Model 275 with same round gearbox used for Model 125.
Features:
Designed for reliability and quiet operation • Rugged die cast gear housing • Output shaft may extend from
front, rear, or both ends and is supported by bronze sleeve bearings • Mounting is compatible
with other pear-shaped motors • Integral RFI filtering can be furnished • Totally enclosed fro protection
against contaminants • Options available...consult factory
Rated Torque
Curves below typify rated torque outputs for standard 6, 12, and 24 volt motors. Values may vary ±15% and are to
be used only as a guide to determine available performance.
|
Voltage
| Rated Voltage |
Operating Voltage |
| 6 VDC |
3-8 volts |
| 12 VDC |
9-18 volts |
| 24 VDC |
19-30 volts |
Current Draw
| Voltage |
Rated Load |
No Load |
| 6 VDC |
70mA |
16mA |
| 12 VDC |
60mA |
30mA |
| 24 VDC |
35mA |
15mA |
|
Dielectric and Insulation Resistance
Dielectric: 1000 volts RMS for one minute between terminals and case.
Insulation Resistance: 10 megohm minimum measured with 500 VDC applied.
R.F.I.
The 200 motor is availble with an integrally assembled radio frequency filter to supress RF noise and enhance brush life.
Output Shaft Options Available
|
|
Current draw may be higher in certain units depending on the type and amount of lubrication used in the gear trains
Ambient Operating Temp. Range
-20°C to +60°C
Lubrication
Permanently lubricated. Special lubricants available for operation under -20°C...consult factory (-40°C min.)
Direction of Rotation
DC Motors may be operated in either direction depending on polarity as applied to the terminals. Direction of rotation
of the output shaft with respect to polarity markings of the terminals will depend upon the number of gear reductions
used in the gear train. Instantaneous reversing is not recommended in order to provide maximum brush life.
Bi-directional DC Motors available.
|
|
|
